Technical Data Sheets - Master List Accessories by TDS #
Complete list of Technical Data sheets for information on specs, measurements, applications and instructions on all Norse Products
TDS 127-1 | Cover Buttons
TDS 128-1 | Cover Plates
At times it is desirable to cover unused Latches, Receivers or Mortise cuts on wall panels or table edges, etc. For this purpose we have designed these plastic Cover Plates
TDS 147-1 | 'T' Handle Hex Keys
TDS 148-1A1 | Handles for Norse Latches
Usually permanently mounted, there are several ways of attachment for both single and double handle and remote operation.
TDS 148-1B1 | H3 Handles for Norse Shroud Latches
Shroud Latches are often operated by a handle protruding from under an equipment case, traveling thru a slot which can be covered with a pliable material that restricts access by polluting matter (dust, etc). Shroud Latches are often mounted in pairs inside each side of the case, necessitating left- and right-hand units as shown here.
TDS 148-2A1 | Hub Handles H4-1A and H4-2A with Plastic Tips and Knobs
The Hub Handle accepts a wide variety of ‘grips’ used to operate Norse latches. Shown here are four simple and economical types: the H4-1 and the H4-2, each with a plastic tip or a plastic knob. Additional grip styles are forthcoming.
TDS 148-3A1 | H6-1 Flag Handle and H10-1 Short Handle
The aesthetic appearance of the polished stainless steel or bronze H6-1 and H10-1 handles has gained popular acceptance for door and window applications. See TDSs 17, 37, 63 and 122.
TDS 151-1 | Ratchet Wrench Set RW7/32x5
This Set Consists of a Double-Ended Offset Ratchet Wrench and Five (5) Various Length 7/32"/5.5mm Hex Bits in a Plastic Case
TDS 154-1 | Components for 'Ganged' MultiLatches®, and/or Remotely Operating Latches
SHOWN HERE ARE BEARINGS, COLLARS, COUPLINGS, SLEEVES, SHAFTS, GEAR BOXES AND COVER BUTTONS USED IN ASSEMBLING GANGED AND/OR REMOTELY OPERATED ATTACHMENTS