TDS 118 Series
Browse through these Technical Data Sheets to help you find technical information, measurements, applications or options for these Norse Latch Systems. Or use the complete list below to choose the most appropriate Information Sheet.
TDS 118-1 | Type 3 Latches • GangedUSED FOR JOINING STRUCTURAL PANELS, EQUIPMENT ATTACHMENT, CASE CLOSURES, ETC. , WHERE MULTI-POINT SIMULTANEOUS LATCHING IS REQUIRED. MANY DIFFERENT RECEIVERS CAN BE USED. “GANGING” NORSE LATCHES (TYPE 1, TYPE 2 AND TYPE 3) SPACED APART USES A COMMON SHAFT THRU TWO OR MORE LATCHES THAT CAN BE OPERATED FROM EITHER END OF THE SHAFT. INSERTION OF THE SHAFT CAN BE DONE THRU THE ACCESS HOLE AFTER PANEL FABRICATION (SEE FIGS. 2 & 3), OR, IF THE PANEL INTERIOR IS ACCESSIBLE, ASSEMBLE THOSE ELEMENTS BEFORE PANEL CLOSURE (SEE FIGS. 1 & 4).
|
TDS Sheet Results
Listed by TDS # and Title-
USED FOR JOINING STRUCTURAL PANELS, EQUIPMENT ATTACHMENT, CASE CLOSURES, ETC. , WHERE MULTI-POINT SIMULTANEOUS LATCHING IS REQUIRED. MANY DIFFERENT RECEIVERS CAN BE USED. “GANGING” NORSE LATCHES (TYPE 1, TYPE 2 AND TYPE 3) SPACED APART USES A COMMON SHAFT THRU TWO OR MORE LATCHES THAT CAN BE OPERATED FROM EITHER END OF THE SHAFT. INSERTION OF THE SHAFT CAN BE DONE THRU THE ACCESS HOLE AFTER PANEL FABRICATION (SEE FIGS. 2 & 3), OR, IF THE PANEL INTERIOR IS ACCESSIBLE, ASSEMBLE THOSE ELEMENTS BEFORE PANEL CLOSURE (SEE FIGS. 1 & 4).
-
USED FOR WIDE STRUCTURAL PANELS, EQUIPMENT ATTACHMENT, CASE CLOSURES, ETC. , WHERE MULTI-POINT SIMULTANEOUS LATCHING IS REQUIRED. MANY DIFFERENT RECEIVERS CAN BE USED. “GANGING” NORSE LATCHES (TYPE 1, TYPE 2 AND TYPE 3) SPACED APART USES A COMMON SHAFT THRU TWO OR MORE LATCHES THAT CAN BE OPERATED FROM EITHER END OF THE SHAFT. INSERTION OF THE SHAFT CAN BE DONE THRU THE ACCESS HOLE AFTER PANEL FABRICATION.
-
USED FOR WIDE STRUCTURAL PANELS, EQUIPMENT ATTACHMENT, CASE CLOSURES, ETC., WHERE MULTI-POINT SIMULTANEOUS LATCHING IS REQUIRED. MANY DIFFERENT RECEIVERS CAN BE USED. “GANGING” NORSE LATCHES (TYPE 1, TYPE 2 AND TYPE 3) SPACED APART USES A COMMON SHAFT THRU TWO OR MORE LATCHES THAT CAN BE OPERATED FROM EITHER END OF THE SHAFT. INSERTION OF THE SHAFT/SLEEVE CAN BE DONE THRU THE ACCESS HOLE AFTER PANEL FABRICATION.
-
USED FOR WIDE STRUCTURAL PANELS, EQUIPMENT ATTACHMENT, CASE CLOSURES, ETC. , WHERE MULTI-POINT SIMULTANEOUS LATCHING IS REQUIRED. MANY DIFFERENT RECEIVERS CAN BE USED. “GANGING” NORSE LATCHES (TYPE 1, TYPE 2 AND TYPE 3) SPACED APART USES A COMMON SHAFT THRU TWO OR MORE LATCHES THAT CAN BE OPERATED FROM EITHER END OF THE SHAFT. INSERTION OF THE SHAFT, COUPLING AND COLLARS NECESSITATES HAVING ACCESS TO THE PANEL INTERIOR BEFORE CLOSURE.
|
|
|
