TDS 115 Series
Browse through these Technical Data Sheets to help you find technical information, measurements, applications or options for these Norse Latch Systems. Or use the complete list below to choose the most appropriate Information Sheet.
TDS 115-1 | Type 3 Latch S1250-3-1.125 Type 2 RSL Short Slotted ReceiverFOR JOINING THICK PANELS TO THIN PANELS AT ‘T’ AND CORNER JOINTS
|
TDS Sheet Results
Listed by TDS # and Title-
FOR JOINING THICK PANELS TO THIN PANELS AT ‘T’ AND CORNER JOINTS Attaching a Thick Panel to a Thin Panel in a ‘T’ or Corner Joint Without Penetrating the Thin Member Can Be Readily Accomplished Using a Type 3 Latch and a Shallow Type 2 RSL Receiver in a Blind Mortise as Shown in These Illustrations.
-
FOR JOINING THICK PANELS TO THIN PANELS AT ‘T’ AND CORNER JOINTS, WITH TYPE 3 LATCH MOUNTED BEHIND FRAMING The Type 3 Latch (S1500-3-625) Mounted Behind a Panel Frame is Frequently Used Throughout a Panel System (See TDS 109) On This Page We Show How a Type 3 Latch in That Mounting Can Be Used With a Shallow Type 2 RSL Receiver Flush Mounted in a Blind Mortise, to Make a ‘T’ or Corner Attachment To a Thin Panel
-
FOR JOINING THICK PANELS TO THIN PANELS AT “T’ AND CORNER JOINTS The Type 2 RSLS Receiver is Shallower and Shorter in Length (.437”/11.1mm X 4.625”/117.5mm)Than the Standard Type 2 Short Receiver Which is (.500”/12.7mm X 5.750”/146mm) Attaching a Thick Panel to a Thin Panel in a ‘T’ or Corner Joint Without Penetrating the Thin Member can be Readily Accomplished Using a Type 3 Latch and a Shallow Type 2 RSLS Receiver in a Blind Mortise as Shown in These Illustrations
-
FOR JOINING THICK PANELS TO THIN PANELS AT ‘T’ AND CORNER JOINTS, WITH THE TYPE 3 LATCH MOUNTED BEHIND FRAMING The Type 2 RSLS Receiver is Shallower and Shorter in Length (.437”/11.1mm X 4.625”/117.5mm) Than the Standard Type 2 Short Receiver Which is (.500”/12.7mm X 5.750”/146mm) The Type 3 Latch (S1500-3-625) Mounted Behind a Panel Frame is Frequently Used Throughout a Panel System (See TDS 109) on This Page We Show How a Type 3 Latch in That Mounting can be Used With a Shallow Type 2 RSLS Receiver Flush Mounted in a Blind Mortise, To Make a ‘T’ or Corner Attachment To a Thin Panel
-
FOR JOINING THICK PANELS TO THIN WALL PANELS OR TUBING Attaching a Thick Panel To a Thin Panel or Tubing can be Readily Accomplished Using Type 3 Latch and a Type 2 Short Slotted Receiver Inserted Thru a Slot in the Thin Wall and Fastened in Place. The Receiver Has Integral Factory Installed Nut Inserts For Attachment as Specified by the Part No. RSL500-2-187/8-32
|
|
|
