FOR SURFACE OR
FLUSH MOUNTING
TYPE 2 LATCHES
THIN FOR MORTISING
TYPE 3 LATCHES
FLANGED FOR MORTISING
SHUTTERUP® LATCHES
hurricane shutter
latching systems
SX LATCHES
COMPACT,
STAINLESS STEEL
MIL-STD LATCHES
MIL-SPEC
5340-01-432-4353
RECEIVERS
ENCASED, NON-ENCASED
ACCESSORIES
GEARHEADS Screws,
HANDLES, KEYS
Technical Data Sheets - Master List Type 2 by TDS #
Complete list of Technical Data sheets for information on specs, measurements, applications and instructions on all Norse Products
TDS 95-2B2 | Type 2 Latches and the Large 'O' and 'OD' Receivers
Shown below is another of many possible panel arrangements using Type 2 Latches with the OR250-3.5 ‘O’ Receiver. Type 1 and Type 3 Latches can also be used. See TDS 48 for Type 1 Latches and ‘O’ Receivers.
TDS 95-2C1 | Type 2 Latches and the Large 'O' and 'OD' Receivers
The full scale illustrations on these sheets show the capacity of the several sizes of ‘O’ Receivers to accommodate panels of different thicknesses and arrangements. Type 1 and Type 3 Latches can also be used. See TDS 48 for Type 1 Latches and ‘O’ Receivers
Shown below is one of many possible panel arrangements using Type 2 Latches and the OR250-4.5 Receiver.
TDS 96-1 | Type 2 Latch and Frame Tubing Receivers
FOR EXHIBITS, STORE FIXTURES, OFFICE PANELING, MODULAR EQUIPMENT, ETC.
Type 2 Latches can be used on tubular framed paneling to make in-line butt joints, ‘T’ & corner joints, and also 4-way posts utilizing a slot in the attached tubular framing as a Receiver.
TDS 96-2A | Type 2 Latch in Tubular Framing using a Slot Receiver
THIS APPLICATION SHOWS THE MOUNTING METHOD AND SLOTTING NECESSARY FOR THE INSTALLATION OF THE LATCH THROUGH THE TUBING SLOT
TDS 96-2B | Type 2 Latch in Tubular Framing using an 'RSL' Receiver
THIS APPLICATION SHOWS THE MOUNTING METHOD AND SLOTTING NECESSARY FOR THE INSTALLATION OF THE LATCHES & RECEIVERS THROUGH THE TUBING SLOTS
TDS 97-1 | Type 2 Latch and Rod Receiver
THE ROD RECEIVER CAN BE USED AT ALMOST ANY ‘SETBACK’ WITH ANY LATCH, PLUS PROVIDING OTHER ADVANTAGES
